• Deutsch
  • English
  • Français

Wire Rope System 5020

Square (basic form) trellis system; also possible as a rectangular "standing" or "lying" (horizontal) installation, thus compatible with small and medium-sized areas. Please refer to the guidelines in the section on climbing plants for support in choosing a suitable construction style. If the climbing aid is installed rectangularly, more wire rope may be necessary (see below). When needed, consult the suitability references for the the related systems 4030 or 8010.

Order as a kit: parts list, information and assembly tips

EasyLightMediumHeavyMassive
 17-30 € 49.80 € 63-120 € 124.80 € 169.80 €
InfoInfoInfoInfoInfo
InstallationInstallationInstallationInstallationInstallation

The pre-assembled kits are suitable for all wall types except insulation, cladding, and thin-walled concrete elements. Alternatives can be put together in all cases.

 

Height x Width: standard up to approx. 1.4 m x 1.4 m; for Heavy/Massive Kits 1.9 m x 1.9 m. With more wire rope *and* a wall mount in the middle (instead of a free-floating cross clamp): also up to 3.0 m x 3.0 m; with a Heavy/Massive construction, even up to 4.4 m x 3.6 m. Base point approx. 0.5 - 1 m above the ground.

 

Variations: either: as a horizontal rectangle and thus an inexpensive alternative to 8010-- then up to approx. 1.2 m x 3.2 m (for a Heavy Kit- 1.2 m x 4 m), or: as a standing stationary rectangle and inexpensive alternative to system 4030-- then up to max. approx. 3 m x 1.0 m (for a Heavy Kit up to 4.4 m x 1.0 m). Then place the middle horizontal rope slightly higher here to achieve a design effect according to the "golden ratio" (see photo). Please check in each case to see if more rope is needed than is provided in the kit.

 

Installation: carried out as shown in the diagrams; please also refer to the installation tips above (click on kit for details).

 

Vine Training/Shoot Guidance: See the related wire rope systems 4030 and 8010.

Easy Kit, vertical/('standing') rectangular form, vine growing. The middle horizontal cable is laid a little higher and brings aesthetic tension to the kit ("golden ratio").
Wall trellis for vines
High assembly/set-up in a heavy construction style, clematis
Steel cable for clematis
Medium Kit, clematis. In the (here: upper) edge area of walls, mounts must be glued instead of dowelled ('plugged/anchored') with composite mortar to prevent cracks due to expanding pressure.
Small lattice
Medium Kit modified, façade green with a an annual (one-year) plant
Façade greening with annuals in pails
Small vine
Small vine
Easy Kit, vertical ('standing') rectangular form analogous to system 4030, clematis viticella. The upper three eyelets should be glued in (here, at the top of the wall) to avoid spreading pressure.
Climbing support cables for clematis
Heavy Kit modified analogously to system 8010, rectangular form, base/pedestal trellis for vine shoot
Trellis with wire rope
A Heavy Kit modified analogously to 4030, honeysuckle
Façade greening with annuals in pails
Easy Kit
Light / Medium / Heavy / Massive Kit