This angled basic form is for framing windows and similar wall openings, particularly in small, cramped areas. The short wire "bridges" situated in the middle offer the plants an additional "grip.” With more supports and holders, the basic form is expandable as desired. Also, a reduced version (see photo) is possible. If more space is available, the basic form 2060 is more advisable. Please also use our references for the choice of a suitable style in the section on Climbing Plants.
Order as a kit: Parts list, information and assembly tips
|24-41 €||59,80 €||87-150 €||149,80 €||207,80 €|
Height x breadth: max. 3 m x 3 m (with a heavy/massive kit 3.6 m x 3.6 m). Distance between the two wires: approx. 15 -50 cm. Please notice that for a harmonious system the small "wire bridge" in the vertical part of the system should be at the center of the longer outer wire whereas for the "bridge" in the horizontal area, take the average length of each the short and long outer wire rope, divide it, and starting from the right side measure off the resulting length and install the bridge appropriately. Base point approx. 0.5, 1.2 m over the ground. With more wire and supports the basic form is arbitrarily expandable. Then approx. every 1.5 m to 1.8 m plan to provide inter-supports. If necessary please ask us.
Installation: is carried out as shown in the graphics. In addition, take into account install. tips (above).
Shoot guidance: See graphics. Columnar vine, and up top a horizontal cordon. Usually short cut, top medium long, with pining or inserting the green shoots to the outer wire rope. The new shoots should then only be on one side, so to grow out toward the outer rope (R-01). Also 2 stems parallel from one vine ('palmette'), but then with a minimum distance of 70 cm from wire to wire, upbringing, as Garland (R 02). Parallel guidance of two trunks, either from one pit or from separate pits (R 03).