• Deutsch
  • English
  • Français

Wire Rope System 1020

1020 is a taut wire rope with two holding ends (attachment points), especially suitable as a single rope for narrow, low wall areas between windows, or for plant support. Often also used in groups mounted to walls, wall bases, pedestals, etc.. -- then modified to system 8020. Please also note the special forms with floor mounting, roof mounting, etc.. To select a suitable design, please refer to the guidelines in the section on climbing plants.

Order as a kit: Parts list, information and assembly tips

EasyLightMediumHeavyMassive
£4.5-8.1£~10.00£~14-27£27£36
5-9 €10,80 €15-29 €29,80 39,80 €
InfoInfoInfoInfoInfo
InstallationInstallationInstallationInstallationInstallation

The pre-assembled kits are suitable for all wall types, but not for insulation, cladding, and thin-walled concrete elements. Alternatives can be put together in all cases.

 

Height: Maximum 1,5 m (with heavy / massive kits 2,2 m). Anything higher, please use system 1030. Base point at 0,3 - 0,7 m over ground.

 

Installation: Used as shown on the graphics, please also observe the installation tips (see above).

 

Guiding Shoots and Vines: See graphics. For compact shoot / vine (R 01) or small garland (R 02). With 3 horizontal cables parallel to each other also ideal as a small espalier with bows (R 03). Distance of the ropes from each other then approx. 20 cm.

Greening with cable systems 1020/1030, Massive Kit, Dutchman's Pipe
Espalier system for plants
Roses on a climbing system 1020 (x2) directly installed into insulation with insulation fixings (rawl plugs)
Wire rope systems on insulation
Massive Kit
Massive wire rope system for climbing plants
Easy Kit
Light / Medium / Heavy / Massive Kits