A single cable stretched between two attachement points, the 1020 is especially suitable as a single rope for narrow, low wall areas between windows, or as an extra plant support. Several 1020s can be mounted to walls, wall bases, etc.. (when combined can be modified into a system 8020). Please also take note of special forms required for floor mounting, roof mounting, etc.. To select a suitable design, please refer to the guidelines in our section on climbing plants (charts at the bottom of each plant profile).
Order as a kit: list of parts, information, and assembly tips
|5-9 €||10.80 €||15-29 €||2.80 €||39.80 €|
The pre-assembled kits are compatible with all wall types, with the exception of walls with exterior insulation, cladding, and thin-walled concrete elements. You can find alternative attachement solutions for each of these cases by following the links.
Height: Maximum 1.5 m (with heavy / massive kits 2.2 m). Anything higher, please use system 1030. Base point at 0.3 - 0.7 m above ground.
Installation: As shown in the diagrams; please also observe the installation tips (see above).
Training Shoots and Vines: See diagrams. For a compact vine (R 01) or small garland (R 02). With 3 horizontal cables parallel to each other, also ideal as a small espalier with 'ribbons' (R 03). Distance of the ropes from each other then approx. 20 cm.