• Deutsch
  • English
  • Français

Stainless Steel Cable Tensioner SP 03000

Wire rope tensioner

Product sheet

Description/Price

"Good and quick" is the tagline for this tensioner. Even if it's not the "hit" in terms of design, its functionality is most compelling! Severing the wire/cable as with other turnbuckles is not necessary. Tensioning is done with a standard open-ended wrench and not with any special tools. Therefore, this quick tension adjuster makes it possible to re-tension at any time. Tensioning can be carried out in fine increments, so that even relatively short wires can be tensioned. Completely made of Nirosta stainless steel, namely of rust-resistant zinc (die-cast). >>> Price

 

Use

Cable tensioner for all common cable thicknesses up to 3 mm, conditionally also for 3 mm wire rope. Also available as a fence tensioner. It can also be used on pre-tensioned, slack wires (quick release). An ideal solution for espalier wires, laundry "lines," tension wires in wire mesh fences, and anywhere else where wire needs to be re-tensioned. Please refer to the general information about cable clamps, etc.. for extra support when needed.

 

Installation

For assembly procedure-- see photos. Use protective gloves! First, place the housing of the wire tensioner on the wire without the anilox roller, then insert the anilox roller so that it grips/catches the wire. Engage the ratchet clamp/strap and then turn the anilin roller with a wrench to tension the wire in finer increments.

 

Origin

Made in Germany

cable tensioner
Built-in tensioner
Installing cable tensioner
Positioning of the body on the cable
Installation
Importing the grid roller
Finishing the installation
Fastening the grid roller