• Deutsch
  • English
  • Français

Wire Rope System 2030

This is an economical version of the basic form 2050 and used when, due to cramped conditions, three cables can't be set up above. The vertical lead wire often only serves as stem lead or guidance. The short vertical wire in the middle offers the plants an additional "handle." Please also refer to the suggestions in the Climbing Plants section for your choice in a suitable construction style. 

Order as a kit: Parts list, information and assembly tips

EasyLightMediumHeavyMassive
17-30 €44,80 €65-120 €119,80 €159,80 €
InfoInfoInfoInfoInfo
InstallationInstallationInstallationInstallationInstallation

 

The pre-assembled kits are suitable for all wall types, but not for insulation, cladding, and thin-walled concrete elements. Alternatives can be put together in all cases.

 

 

Height x breadth: max. 3.5 m x 3.0 m (with a heavy/massive  kit 4.0 m x 3.6 m), distance between the horizontal ropes: approx. 15 -50 cm. Base point approx. 0.3- 1.2 m above the ground. With more cable and holders the basic form is arbitrarily expandably. Then there should be a holder approx. every 1.5 m to 1.8 m. If you have any questions, please ask.

 

Installation: is carried out as shown on the graphics. Take into account the assembly tips (above). Please contact us with any questions.

 

Shoot guidance: See graphics. Horizontal-cordon, with attachment or insertion of green shoots on the top rope (R 01). If with leafy stem, then as a garland. Two plants in a planting pit with the separation of vertical cordon and horizontal cordon, especially at high altitude and / or width, where the angled vine is then running in the vertical area with un-leafy trunk. With two plants in one pit or - in case of planting the vertical vine later - two separate planting pits (R 02). Also 2 parallel garlands from one vine, then the minimum distance of the two lines above should be approx. 70 cm (R 03).

Medium Kit on a garage, honeysuckle...
Wire rope system on a garage
Medium Kit for a climbing rose
Wire rope tensioning system for roses
A Simple Kit modified for small kiwi in a bucket.
Espalier system for Actinidia
Ivy "tree” Hedera helix of “Arborescens.”
Climbing support system for Ivy "Arborescens"

Grapevine training on system 2030

R 01
R 02
R 03
A heavy construction design modified with WM 12XX8 on an outer insulation wall. Extended and supplemented above with an additional "cable bridge" with 2 mounts. Climbing Roses in the system.
Greening with wire rope
Easy kit
Medium kit "Classic"
Light / Medium ("Eco" and "Premium"), Heavy / Massive kits