Trellis Fitting "Quadro", GH 05060

Product Sheet

Description / Price

Set of 4 clip holders (fittings). Available in white. With countersunk screw 5/60 mm made of stainless-steel 304 and collar plug DH 08050. >>> Price.

 

Use

These fittings are a cost-effective solution for fixing medium-sized stainless steel trellises with 4-6 mm wires to a facade. For light loads only. For low heights up to approx. 2.5 m. Wall distance 30 mm. For almost all wall surfaces, such as concrete, natural stone, solid and hollow masonry, solid wood or wall panels. Please also refer to the general information on how to mount steel trellises securely.

 

Assembly

Drill a hole 8 mm wide and 6 cm deep. Alternatively, the screw can be fitted with a 6 mm rawl plug, but will not achieve the same stability. Smaller screws and rawl plugs can be used, especially with concrete surfaces, to reduce the size of the bore hole to 5 mm. After drilling, the plugs are inserted in the hole (no plugs for solid wood, but pre-drill a 3 mm hole). Screw on the fittings and then press the trellis into the clips of the fitting. You can mark the drilling points easily by clipping the fittings onto the trellis first and use this to mark the exact bore positions before drilling.

 

Origin

Merchandise