• Deutsch
  • English
  • Français

Hobby - Wire Cutter SC 33777

Wire rope cutters

Product sheet

Description / Price

Wire cutter / wire cutters suitable in amateur quality, for wire and cable also. Heavy construction compared to conventional wire cutters, scissors shape. Rugged, forged in one piece cutting arms without riveting. Hardened tool steel, grip areas coated with plastic tubing (protection against cold grip), with locking tab. Probably an imitation of the US brand 'H.K.Porter'. The attractive price is due to the simple design without rivets and from the inexpensive cutting steel. >>> Price

 

Use

Very robust wire cutter for cutting wire and wire rope, also made of stainless steel. The manual force required in each case are higher than with SC 34000 and SC 34999 Smooth, clean cut without unraveling the ropes. The following diameters can be cut with wire cutters: Hardened spring steel up to 2 mm, softer steel wire and hard wire ropes Stainless steel (strand 7x19) to 2.5 mm, medium soft wire ropes Stainless steel (wire 7 x 7) to 3 mm, in exceptional cases up to 4 mm, soft wire stainless steel (wire 7x19) to 4 mm, soft aluminum ropes, etc. to 5 mm. For occasional use. Please use, if necessary, the general information on cable cutters.

 

Please note

The wire cutter is not as suitable as the Felco SC 34000 or SC 34999, the cutting edge of steel is made of lower quality not for frequent or even continuous use. Even when cutting more force is required. After approximately 20 (4 mm rope) or 50 sections (3 mm rope) increased the cutting effort again due to decreasing sharpness. There are then, but still depending on the rope diameter, many hundred cuts possible. Riveting issues do not occur at all due to the design. 

 

Origin

Made in China

Wire-cutters made in China
Those blue wire cutters are the cheapest available on FassadenGrün
Wire cutter with 4 mm cable
Hobby wire cutter with a wire rope 4 mm
Drahtschneider - Schnitt
Clean cut, thanks to the wire cutter