• Deutsch
  • English
  • Français

Wire Rope Trellis Fitting "Eco" w. Plug, WH 08111

Distanzhalterung aus Edelstahl für Drahtseil / Stahlseil / Edelstahlseil

Product sheet

Description / Price

Small cross mount (distance holder) made of stainless steel, shaft 8 mm, cross head d= 15 mm with grub screw, hexagon flange nut, convex thrust washer, laminated gasket, and collar plug DH 10065. The head is also available separately. >>> Price



Standard holder for Medium "Eco" Kit according to the specifications of the respective wire rope system. Inexpensive alternative to WH 10151, for rather low loads. For 3 mm cable, simple or crosswise cable guidance. The distance from holder to holder should not exceed 1.5 m, if possible. Compatible with almost all wall types (please refer to the link). Also suitable for panel building materials with a material thickness of at least 40 mm. For thinner flat plate walls, see below. Wall clearance 5 cm. Please also refer to the information provided as support for choosing suitable rope cross mounts/holders.


Recommended tool

For accurate dowel holes (10 mm): hammer drill HB 44444. Alternative to impact drill: concrete drill, less the expensive masonry drill, or universal drill; selection also depends on wall type.



If necessary, refer to the information on drilling work. Drill a 10 mm hole, approx. 7-8 cm deep. In solid wood without plugs (dowels): pilot drill approx. 6mm, front 7 mm. For optimal sealing, the surface should be reasonably level or made so by sanding down. Grease the shaft a little, taking hold of the mount on the hexagon flange nut with an open-ended wrench, and screw in. Further assembly is carried out as described for Medium Kits.



Own production: "made in Germany" -- head from Saxony, shaft from Lower Saxony, pressure washer from North Rhine-Westphalia, plug from Baden-Wurttemberg; small parts from the Far East.

cross mount in solid wood
cross mount M8 "Eco", solid wood
High grade stainless steel cross-mount
Wire rope for grapevine