• Deutsch
  • English
  • Français

Wire Rope Cross Mount M8, w. Anchor WM 08133

Drahtseilhalter aus Edelstahl für Stahlseil / Edelstahlseil

Product sheet

Description / Price

High quality cable holder or 'cross mount', stainless steel V4A, smooth shank 8 M, cross head d= 15 mm with grub screw, hex flange nut, pressure washer d=7.9 mm with bonded seal, special fixings. A similar head is also available separately. >>> Price



For wire-cable 3 mm, standard support for medium kits "Premium", in accordance with the specifications of the respective wire rope system if bought as pre-assembled kit. The distance of support to support shouldn't exceed 1.5 m, if possible, with simple or crosswise cable guidance. Works on nearly any wall types, please check the link for suitability. Also in board/slab materials with at least 40 mm material thickness, thinner plates , see below. Wall distance 6 cm. Please use the information on the selection of appropriate cross mounts.



If necessary, please notice the leaflet about drilling work. Establish drilling 10 mm, approx. 9 cm deep into massive wood without plugs (approx. 6mm pilot drill, in front 7 mm). The underground should be flat to some extent or made so for optimal insulation. Grease the shaft a little, taking hold of supports at the hexagon flanged nut with an open-ended spanner and turn. The further installation is done as described for medium kits.


Special Features

You can intsall into a wall joint at fairfaced masonry with 17.5 mm breadth, then without washer/seal.

With hollow brick, pilot-drill, start small and carefully and without pressure drilling, drill 10 mm. Should the plug still turn in the hole, bore on 12 mm carefully and use long plugs DL 12090, we will, if necessary, deliver this plug without charges. 

Second alternative: bore 16 mm, set sieve sleeve SD 16085 with mortar and paste the white special anchors there. After drying, remove any motar within the plug by drilling it away with a 6 mm drill.

For through-hole assembly a counter-set is available.



Our own "made in Germany", head from Saxony, shaft and thrust washer from North Rhine-Westphalia, plug from Baden-Wurttemberg, small portion from the Far East

Wire rope support on cladding
Cable holder installed in 27 mm larch formwork with underlying glue wood posts (Version 04 -. See 'attachment'), grapevine
Stainless steel wire rope system
Robust and almost invisible: System 7050 on a concrete wall
Eindrehen des Halters
Screw in of the wire-cable support