• Deutsch
  • English
  • Français

Cable Cross Mount M10 "Classic" w. Anchor, WH 10151

Wandhalter aus Edelstahl für Drahtseil / Stahlseil / Edelstahlseil

Product sheet

Description / Price

Wall holder (bracket) or "cross mount" made of stainless steel, shaft M10 / H9, 18 mm, crosshead d=18 mm with grub screw, lock nut, hexagon flange nut, special support washer d = 32/8.9 mm, gasket and long plug (dowel). The head is also available separately.  >>> Price

 

Use

For 3 mm cable, standard holders for Medium "Classic" Kit, in accordance with the specifications of the respective wire rope system, sometimes used in conjunction with WH 10150. Simple or crosswise cable guidance. The distance from holder to holder should not exceed 1.5 m, if possible. Especially for hollow bricks, but also compatible with many wall types (check suitability via the link). Can be used with panel/board building materials if anchoring in surface is possible and material thickness is at least 60 mm. Wall clearance 6 cm. Please also refer to the selection on cross mounts for selecting a suitable mount/holder.

 

Recommended tool

For accurate dowel holes (12 mm): hammer drill HB 44444. Alternatively: concrete drill, inexpensive masonry drill or universal drill; selection also depends on wall type.

 

Installation

If necessary, refer to the instructions on drilling work. Usually used with long plug/dowel DL 12090. Grease shaft a little, drill a 12 mm hole approx. 10 cm deep. For panel building materials: with plug/dowel DH 12075; in solid wood: without plugs/dowels (pilot-drill approx. 8 mm, 9 mm in front). For optimal sealing, the surface should be reasonable flat or made so (sanded down). With a 15 mm open-ended wrench, take hold of the mount on the flange nut and turn (screw in). Further assembly is carried out as described for Medium Kits.

  

Special Features

For special cases (e.g. with 1.8 mm cable), the wall mount is available with a longer shaft than WH 10181 (at no extra charge) and then has an 8 cm distance to the wall.

 

Origin

Our own "made in Germany" production (Saxony); hexagon nuts from the Far East

Cross mount M10
wall mount WH 10151 with Honeysuckle
Halter für Fachwerk
Into massive wood
Wire rope with end sleeve
In plastered masonry
Seilverspannung für Begrünung
Underlying in wooden casing with laths, wood thickness 70 mm.