• Deutsch
  • English
  • Français

Ringbolt (Eye bolt) 6/30 mm, WM 06030

Ringbolzen Edelstahl

Product sheet

Description / Price

Ringbolt made of high-grade steel with an eye built up with weld and backing pad, counter-thrust washer, spring washer and permanent washer, metric thread M 6  >>> Price



As a final and intermediate holder for cable and wire for through-hole mounting in wooden slats, -planks and similar detached components. For wire diameters up to 3 mm, as well as intermediate support to 4 mm. Wall distance about 1.5 to 2 cm. Advantageous everywhere where due to low material strengths, other wall holder with wood thread no longer can be used. With cavity plug HD 06050 the element is for wood panelling, etc. can be used with metric dowel DM 06025 for ' sack ' holes in very thin concrete cross-section and for pre-fab garages if a hole leads to material flaking on the inner wall. In both cases the rear parts are then not mounted. In addition we then provide, free of cost, a seal - please,  write a remark in the order if desired. If necessary, please use the information about the choice of suitable eyelet bolts.



Please notice the info on the drilling sheet! Through hole > 6 mm manufacture, insert bolts without moving parts on the front and back screw with the associated elements (washer, spring washer, nut).


Special Features

The backing pads cuts on the front side in a little way into the material and leaves a dish-shaped imprint after a dismantling. The element WM 08080 is alternatively available for assembly in larger material crosscuts.



Production after drawing from the Far East

Ringbolzen Vorderseite
Ringbolzen Rückseite
Montierte Ösen