Description / Price
Countersunk head screw 6/120 mm of stainless steel with partial thread, Torx head and anti-friction coating, set of spacer elements five-part made of stainless steel, plastic collard plugs DH 10065. >>> Price
For permanent corrosion-free wall fastening of customary wooden espaliers and especially for crossbars of classical espaliers. With a small wall spacing (gap) of about 10 mm. The actual wall spacing arises from the wall gap and the amount of the unscrewed cross sections. In the case of the battening 25/25 mm, it accounts for about 60 mm. For plastered and non-plastered masonry made of solid or hollow bricks.
For medium loaded espaliers used for vine, Clematis, climbing Roses and so forth. In the case of large espaliers it is necessary to set a universal anchor per bar at a spacing of 0.6 to 1.0 m. For heavy loaded espaliers with fruits, Chinese wisteria and others, the anchor bolt AS 12XX0 should be chosen. Please use the general information of espalier fastening, if necessary.
For custom-fit dowel holes (10 mm) hammer drill HB 44444. Alternative for impact drills, concrete drills, inexpensive stone drills or universal drills, selection also depends on the wall type.
Please note the exampley and details of the planning and realisation of wooden espaliers, if necessary! The elements to be fastened get a through-hole of > 6 mm at the respective fastening points, and a sagging of 90 degrees for the countersunk head of the universal anchor, at the outside. The wall receives a bore corresponding to the plug DH 10065 with a cross section of 10 mm.
The screw is plugged through the bar or the respective wooden espalier part, afterwards the spacer elements are placed upon it. Either all or less of the spacer elements may be used, the latter in the case of uneven wall surfaces. If less spacer elements are needed, other screws shoud be picked. The screws should be tightened with a TX-bit.
Stainless steel parts import articles, plugs "Made in Germany"