• Deutsch
  • English
  • Français

Insert Fitting (Screw-in Nut/Plug) ED 01060

Insert Fitting (Screw-in Nut/Plug) ED 01060

Product Sheet

Description / Price

Large insert nut (fitting) / screw-in steel plug for heavy-duty mounting, internal ('female') thread M10 (blind hole) 15 mm long, external wood thread 18 mm diameter, total length 60 mm. >>> Price

 

Use

For special mountings with M10 threads. With this insert nut, the fastening is always done into the solid wood of the respective supports, framework-truss 'shafts', thresholds, etc.. The fastening makes permanently high loads possible. Please refer as needed to our general information on rawl plug (dowel) / anchor technology.

 

Assembly

For optimum mounting, the middle areas of each wooden support should be drilled and the insert nuts screwed in there. Avoid fastening into edge areas whenever possible. When drilling into wood at load-bearing intersection-points, there is a danger that the wooden connecting rivet will be drilled through, impairing its functionality and compromising its load-capacity. The exposed solid wood is drilled 15-16 mm (for softwood) or 17 mm (for hardwood such as oak) and about 65 mm deep for screwing in the threaded fitting. The fitting is then screwed in as far as possible with the special tool (please enquire if necessary) and with your slowly rotating drill... if possible, without deviation from the thread axis. 

 

Origin

Made in Germany (Schleswig Holstein)

Gewindemuffe
Rampamuffe
Framework during renovation, (scaffolded-- blue-grey beams below and left). Top left: two sections are already filled with the loam/straw mixture.
Framework during renovation