Product Sheet
Description / Price
High-quality welded screw eye made of stainless steel with a pressed eye, shaft 8 mm, wood thread H7. Length 110 mm, shaft length 85 mm. >>> Price
Application
Wall mount in our easy basic kit, especially for representative climbing aids- more solid and attractive than WH 07080. As an end and intermediate anchor for cable and wire. For rope diameters up to 3 mm, in exceptional cases up to 4 mm. The distance from eye screw to eye screw should not exceed 1.5 m when possible. Compatible with many wall types (please check suitability using the link). For wall distances of 1.5-2.0 cm, in solid wood up to approx. 2.5 cm. Refer to our general section on eye screws/bolts for more info. and support.
Recommended Tools
For drilling precise 10 mm holes for plugs: hammer drill HB 44444. Alternatively: concrete drill, inexpensive masonry drill, or universal drill; selection also depends on wall type.
Mounting
If necessary, please refer to our instructions on drilling! Use DH 10065 when installing into solid stone, DH 12075 (same link as 10065) for hollow bricks or aerated concrete. Insert the eye screw into the chosen rawl plug and screw in/position using a mandrel or screwdriver inserted transversely through the eye. To ensure maximum strength of the element, the centre of the screw should not protrude more than 2-2.5 cm from the wall. In solid wood, keeping a wall distance of 3 cm is possible. When mounting in solid wood and loading in an axial direction (system 0010), pre-drill a hole with a diameter of 3-4 mm (softwood) or 5 mm (hardwood), depth 8 cm, and possible widen the hole about 25 mm depth to diameter 6-7 mm ( 'step drilling'); then screw in the eyebolt 80 mm deep.
Source
Production based on designs from the Far East
