Modular stainless steel screw eye, shank M 10, with adjusting nut, lock washer, washer d= 9.8 mm, seal and brass plug DM 10030 >>> Price
Special element for medium kits 'Classic' - kits, e.g. for thin-walled pre-fab garages, further special cases see below. For wire cable 3 mm (in the exceptional case 4 mm) in accordance with the defaults of the respective wire rope system, often in connection with WM 10081. Wall clearance approx. 4 - 5 cm. The distance from screwing eye to screwing eye should not exceed 1.5 m if possible. Please also use the information for the selection of suitable eyelet screws.
Please note the leaflet drilling instructions, if needed. For optimal sealing, the underground should be reasonably level or prepared (sanded). In concrete drilling depth 3,5 cm, the brass anchor is then used flush to the wall, please use the product sheet for more info. The ring screw and dowel is inserted and carefully screwed in with a screwdriver of high quality chrome vanadium steel by inserting it through the eyelet...(see corrosion...). Then the nut and washer, etc. is braced with moderate hand pressure against the wall. Further assembly is then described as with medium-sized kits.
For mounting in square pipe, cut thread, on-site, in the post and then directly screw in the screw eye,- installation here best through regional metal construction company. For trapezoidal sheets as a modified version with toggle bolts, please inquire. For panels also with toggle bolts, possibly with extended shaft, please inquire. For special cases, the eyelet bolt would be no extra charge with a longer shaft (120 mm) as WM 10120 available. A counter-fitting is available,with nut, spring washer, and washer through hole mounting in wood posts, etc.
Production "made in Germany" (Saxony), ring eye and hexagon nuts from the Far East.