• Deutsch
  • English
  • Français

Eyelet Screw 6 mm, WH 06060

Eyelet Screw 6 mm

Product sheet

Description / Price

Eyelet screw made of stainless steel with strong 6 mm shaft and milled wood 6mm thread, total length 90 mm, shaft length 65 mm, surface- matt-glossy. Attention: comparable eyelet bolts 6/60 mm from other suppliers usually have a thinner 5 mm shaft with a rolled thread H6 and are therefore less suitable for bending-buckling loads. >>> Price


Use

Standard eyelet for our easy basic-s kits, i.e. for rope diameters up to 3mm. An economical alternative to the larger eyebolt WH 07080. Suitable for trellis wire/ropes at low loads on many wall types. Provides up to 2cm wall distance. The distance from eyelet to eyelet should not exceed 1.5m. Please also refer to the information provided for choosing suitable eyebolts.

 

Recommended tools

For drilling precise holes for plugs (8 mm): hammer drill HB 44444. Alternatively: concrete drill, inexpensive masonry drill, or universal drill; selection also depends on wall type.

 

Assembly

Please refer to our information on drilling! Use rawl plug DH 08050. If mounting into aerated masonry or aerated concrete, rawl plug DH 10065 is better suited. Screw the 6mm eyelet screw as deeply as possible into the wall such that the shaft is almost invisible; this minimises flexural bending stress.

 

Origin

Made in Germany (North Rhine-Westphalia)

Wire rope tensioner
WH 06060 as an intermediate support on a brick facade
assembled eyelet
Eyelet screws (from top to bottom): WH 07080 / WH 06060 / NA 04060
Eyelet screws in comparison
This is how deep the screw must be screwed into the rawl plug.
Stainless steel eyelet screw